Aurigma Graphics Mill 5.5 for .NET

This documentation is for the old version. Go to the latest Graphics Mill docs

Cylindrize Constructor (Single, Single, Single, Single, Single)

Creates new Cylindrize class instance. You can set here cylinder parameters (half-perimeter and height), slope angle, and bitmap position.

Namespace: Aurigma.GraphicsMill.Transforms
Assembly: Aurigma.GraphicsMill (in Aurigma.GraphicsMill.dll)

Syntax

Visual Basic

Public Sub New ( _
	slopeAngle As Single, _
	cylinderHalfPerimeter As Single, _
	cylinderHeight As Single, _
	horizontalOffset As Single, _
	verticalOffset As Single _
)

C#

public Cylindrize(
	float slopeAngle,
	float cylinderHalfPerimeter,
	float cylinderHeight,
	float horizontalOffset,
	float verticalOffset
)

Parameters

slopeAngle: Type: System.Single
Slope angle of the cylinder. It can be changed later via SlopeAngle property.

cylinderHalfPerimeter: Type: System.Single
Positive number specifying half-perimeter of the cylinder. You can also specify -1. In this case width of the bitmap will be taken. This value can be changed later via CylinderHalfPerimeter property.

cylinderHeight: Type: System.Single
Positive number specifying height of the cylinder. You can also specify -1. In this case height of the bitmap will be taken. This value can be changed later via CylinderHeight property.

horizontalOffset: Type: System.Single
Horizontal offset of the bitmap on the cylinder. This value can be changed later via HorizontalOffset property.

verticalOffset: Type: System.Single
Vertical offset of the bitmap on the cylinder. This value can be changed later via VerticalOffset property.

See Also

Reference